ESP32-2432S032 + elm327BT

If you have an ELM327 clone with mac address aa:bb:cc:11:22:33 you can use it with an ESP32-2432S032 to read your engine parameters.If your ELM327 BT have another MAC address just write me and i will send you another firmware. hardware is not included, only bootloader, partitions and eeprom firmware.Easy method to flash esp32(Flash download Tool):load xxxx.bootloader.bin Address: 0x1000load xxxx.partition.bin Address: 0x8000load xxxx.ino.bin Address: 0x10000After Flashing process just reset the board.This zip arhive including too, the case stl for printing on 3d printer.This is a case for ESP32-2432S032 capacitive touch screen assemble from 3 pieces: front, back and 1 buton.It have holes for light sensor, RGB led and 4 screws.It have reinforcement to compensate for deformation if PLA is used for print.The case have raised edge around the screen and a round hole for a circle phone speaker or another buzzer.Second back part have square hole for square buzzer 9x9mm.On the back is reset button for the board.Personally prefer 100% infill with 0.12mm height layer for final product, but it can be print with 0.2mm or higher.I use this case for ESP32 in an automotive Arduino ESP32 project to read temperature or another engine's parameter using an ELM327 BT .3D printing settingsEnder 3 V2, PLA or PETG 0.12 or higher .i prefer 100% infill for final product but can be used stock settings of slicer

Found on Devadex — the discovery index for independent software the big search engines bury. More from gumroad.

Report this listing